Avaya G430 - Page 395

• Use capture lists to select specific traffic.
Starting the packet sniffing service
Procedure
Once you have defined and applied the packet capture lists, use the capture
start command in general context to instruct the packet sniffing service to start
capturing packets.
Result
Note:
The capture start command resets the buffer before starting the sniffer.
Note:
You must apply a capture list using the capture filter-group command in order for
the capture list to be active. If you do not use the capture filter-group command, the
packet sniffing service captures all packets.
If packet sniffing has been enabled by the administrator, the following appears:
Gxxx-001(super)# capture start
Starting the packet sniffing process
Gxxx-001(super)#
If packet sniffing has not been enabled by the administrator, the following appears:
Gxxx-001(super)# capture start
Capture service is disable
To enable, use the `capture-service` command in supervisor mode.
Gxxx-001(super)#
Related topics:
Decrypted IPSec VPN packets on page 395
Decrypted IPSec VPN packets
IPSec VPN packets are encrypted packets. The contents of encrypted packets cannot be
viewed when captured. However, you can use the capture ipsec command to specify that
IPSec VPN packets, handled by the internal VPN Branch Gateway process, should be
captured in plain text format.
Monitoring applications
Administering Avaya G430 Branch Gateway October 2013 395