Avaya G430 - Page 68

Supported S8XXX servers on page 68
MGC list configuration on page 68
About setting reset times on page 71
Example for setting reset times on page 72
Accessing the registered MGC on page 72
H.248 Registration Source Port on page 73
ICC or Survivable Remote Server monitoring on page 73
Summary of MGC list configuration commands on page 73
Locating the Branch Gateway serial number
About this task
To register the Branch Gateway with an MGC, you need the Branch Gateway’s serial number.
You can find this serial number in either of the following ways:
Procedure
1. Use the show system command
2. Look for a 12-character string located on a label on the back panel of the Branch
Gateway
Supported S8XXX servers
The MGCs supported by the Branch Gateway include both ECCs and ICCs. The Branch
Gateway supports the following MGCs:
Table 1: MGCs supported by the Branch Gateways
MGCs
Type Usage
Avaya S8300D Server Media module ICC, ECC or LSP
Avaya S8800 Server External ECC
Dell R610 External ECC
MGC list configuration
The Branch Gateway must be registered with an MGC in order to provide telephone service.
You can set the Branch Gateway’s MGC, and show the current MGC list used to determine
the results.
Basic device configuration
68 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com