Avaya G430 - Page 79

Gxxx-001(config)# ip domain lookup
Done!
Using DNS resolver to resolve a hostname
About this task
Use the nslookup command, followed by a hostname, to resolve the hostname to an IP
address.
DNS resolver maintenance
There are various commands you can use to display DNS resolver information, clear DNS
resolver counters, and display DNS resolver log messages.
Related topics:
Examples of viewing DNS resolver logging on page 79
Examples of viewing DNS resolver logging
1. Enter set logging session enable to enable session logging to the
terminal.
Gxxx-001# set logging session enable
Done!
CLI-Notification: write: set logging session enable
2. Enter set logging session condition DNSC to view all DNS resolver
messages of level Info and above.
Gxxx-001# set logging session condition DNSC Info
Done!
CLI-Notification: write: set logging session condition DNSC Info
Note:
You can also enable logging messages to a log file or a Syslog server. For a full
description of logging on the Branch Gateway, see System logging on
page 215.
DNS resolver configuration commands
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Basic device configuration
Administering Avaya G430 Branch Gateway October 2013 79