You cannot unlock the phone if you enter an incorrect PIN or password. The system administrator
sets the maximum number of incorrect attempts. If you exceed the limit, the phone temporarily
blocks you from attempting to unlock the phone for a period that the administrator specifies.
Before you begin
If you do not know or remember your PIN or password, contact your system administrator.
Procedure
1. Press Unlock.
2. On the Phone screen, enter a PIN or a password.
Setting the network mode
About this task
You can set the network mode to Ethernet or Wi-Fi. You do not need to perform this procedure if
your phone is configured to connect to Ethernet or a specific Wi-Fi network.
Before you begin
Ensure that the system administrator gave you access to perform this task.
Procedure
1. Press Main Menu.
2. Scroll to Settings and press Select.
3. Scroll to Network and press Select.
4. Scroll to Network mode.
The Network mode setting shows the following options:
• Ethernet: To connect to an Ethernet network.
• Wi-Fi: To connect phone to a Wi-Fi network.
5. Press one of the following:
• Toggle
• Right Arrow key
• Left Arrow key
6. When Network mode displays Wi-Fi, the following lines are shown on the Phone screen:
• SSID: The name of the Wi-Fi network that the phone is either currently connected to, or
will attempt to connect to if you start the connection process.
• Wi-Fi network: Scroll to this line and press Select to view the list of Wi-Fi networks.
7. After selecting the network mode, press Save.
Getting Started
February 2022 Using Avaya J159 SIP IP Phone in Open SIP 24
Comments on this document? infodev@avaya.com
To Next Page
Loading...
