Before you begin
•
Turn on the Scopia XT Server for IP Office unit.
•
Verify that you have the four-digit PIN code required to make changes to the system settings. The
default PIN code is 1234.
•
Connect a monitor to system so that you can manage the system from the endpoint's own
interface, as described in Connecting a Monitor to the XT Server on page 25.
Procedure
1. From the endpoint's main menu, select Configure > General.
Figure 66: Enabling advanced settings
2. Set Show Advanced Settings to Yes.
3.
Press the
Back key on the XT Remote Control Unit.
4. Select Advanced.
5. Enter your four-digit PIN code, and press ok/menu. The default PIN code is 1234.
6. Select Utilities > Restore System > Factory Defaults.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Troubleshooting the Scopia XT Server for IP Office | 107
To Next Page
Loading...
