Reference Guide for Scopia XT Server for IP Office API, which includes the list of commands over the
Ethernet interface.
Implementing Port Security for the Scopia XT Server for IP
Office
The Scopia XT Server for IP Office provides video technology for room conferencing, including support
for dual stream 1080p video, high quality data sharing, high quality full band audio and a high-capacity
embedded MCU (selected models).
This section details the ports used for the Scopia XT Server for IP Office and the relevant configuration
procedures:
Navigation
•
Ports to Open on the XT Server on page 18
•
Configuring the TCP or UDP Port Range on the Scopia XT Server for IP Office on page 21
Ports to Open on the XT Server
The Scopia XT Server for IP Office is typically located in the enterprise network and is connected to the
DMZ. When opening ports to and from the Scopia XT Server for IP Office, use the following as a
reference:
•
If you are opening ports that are both to and from the XT Server, see Table 6: Bidirectional Ports to
Open on the XT Server on page 19.
•
If you are opening outbound ports from the XT Server, see Table 7: Outbound Ports to Open from
the Scopia XT Server for IP Office on page 20.
Important:
The specific firewalls you need to open ports on depends on where your XT Server and other Scopia
Solution products are deployed.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Planning the Topology of the Scopia XT Server for IP Office
Deployment | 18
To Next Page
Loading...
