You can use both ports for connecting to the private and public network, however we recommend that
you always connect the private network to the second GLAN port, whether one router interfaces with the
Scopia XT Server for IP Office or multiple routers interface with the Scopia XT Server for IP Office
(Figure 7: Connecting the XT Codec Unit to a private and a public network on page 25).
Figure 7: Connecting the XT Codec Unit to a private and a public network
For more information, see Planning NAT and Firewall Traversal with Scopia XT Server for IP Office on
page 14.
Connecting a Monitor to the XT Server
About this task
To configure and manage your system using the XT Remote Control Unit, you must first connect a
monitor as described below. Otherwise, configure the system from the web interface, as described in
Managing your XT Server from the Web Interface on page 28.
Before you begin
You need an HDMI cable to connect the monitor to the XT Server:
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Setting up the Scopia XT Server for IP Office | 25
To Next Page
Loading...
