Figure 8: HDMI cable
Procedure
1. Connect the cable to the HD1 port on the XT Codec Unit:
Figure 9: Connecting a monitor to the XT Server
2. Connect the cable to the HDMI port on the monitor.
Installing the Batteries of the XT Remote Control Unit
About this task
The XT Remote Control Unit requires CR2025 Lithium batteries (3V). When the XT Remote Control
Unit's battery power is low, an icon appears on the GUI letting you know that you should replace the
battery:
•
Half-charged Battery
•
Low Battery
Important:
When the Low Battery icon appears on the display, we recommend to change batteries immediately,
to ensure proper functioning of the system.
For battery disposal information refer to the Safety Instructions leaflet.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Setting up the Scopia XT Server for IP Office | 26
To Next Page
Loading...
