Chapter 5 | Setting up the Scopia XT Server
for IP Office
After reading the section Prerequisites for Setting up the System on page 23, you can install the Scopia XT Server for
IP Office. These sections describe how to install the XT Codec Unit and connect its accessories:
Navigation
•
Mounting the XT Codec Unit on page 24
•
Connecting Scopia XT Server for IP Office to Your Network on page 24
•
Connecting a Monitor to the XT Server on page 25
•
Installing the Batteries of the XT Remote Control Unit on page 26
Mounting the XT Codec Unit
About this task
Follow the guidelines in this section to correctly place the XT Codec Unit.
Procedure
Place the XT Codec Unit following these guidelines:
•
Place the XT Codec Unit on a horizontal surface which stands firmly on its base.
•
The surface must be dry and free of dust, oil and other residues.
•
Leave enough space for air circulation and for connecting cables easily.
•
Place the XT Codec Unit anywhere within 5 meter reach of the camera cables.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to overheat.
Connecting Scopia XT Server for IP Office to Your Network
About this task
Your Scopia XT Server for IP Office has two GLAN 10/100/1000 ports for connecting to the network.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Setting up the Scopia XT Server for IP Office | 24
To Next Page
Loading...
