Avaya RADVISION Scopia XT5000 - Configuring Call Settings

Parameter Description
Use SIP Registrar Select Yes.
Registrar DNS Name Enter the DNS name or IP address of the IP Office
server.
Use SIP Proxy Select Yes.
Proxy DNS Name Enter the DNS name or IP address of the IP Office
server.
Proxy Model Select Auto.
3. From the web interface only, select Save.
4. (Optional) If you are securing SIP connections using TLS certificates, continue with Securing
Connections to the XT Server Using TLS on page 88.
Configuring Call Settings
About this task
To allow incoming and outgoing calls, configure the following system settings according to your network
requirements, as described in this procedure:
•
Disable the local video and audio and use the system as an MCU only. See the Local audio-
video (MCU) field in Table 14: Configuring general call settings on page 65, below.
•
Network's preferred GLAN
•
Call settings, such as defining calls as audio-only, or specifying the call rate
•
IP settings, such as determining whether the XT Codec Unit checks the source of audio and video
data packets
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint on page 45.
Procedure
1. Access the network priority settings as follows:
•
From the XT Server web interface, select Administrator Settings > Networks >
Preferences > General.
•
From the endpoint's main menu, select Configure > Advanced > Networks >
Preferences > General.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 63