Before you begin
Make sure you have an SNMP scanner tool, typically included in SNMP monitoring software.
Procedure
1. Launch the SNMP scanner tool used in your organization.
A list of all devices in your network appear.
Figure 11: Retrieving the XT Server IP address via SNMP agent discovery
2. Find your XT Server.
3. Open a web browser and enter the IP address.
The web interface opens. You can log in as described in Accessing XT Server Web Interface
on page 34.
Important:
The initial IP assigned to the XT Server is a dynamic IP address. When you first start
configuring the system, we recommend assigning a static IP address by performing the
procedure described in Configuring IP Addresses on page 77.
Retrieving the XT Server IP Address via Serial Port Query
About this task
This procedure describes how to retrieve the XT Server's IP address using a serial port query, with no
additional software required on your computer. This method is useful because it does not require any
additional software on your computer, and can detect devices on a different subnet than your computer.
After retrieving the IP address, you can configure the XT Server from its web interface.
This method is recommended for administrators only. Alternatively, you can also retrieve the IP address
using one of the other methods available:
•
Retrieving the XT Server IP Address via Bonjour on page 29
•
Retrieving the XT Server IP Address via SNMP Discovery on page 30
To configure the XT Server without retrieving the IP address, connect a monitor and manage the system
from the endpoint's own interface, as described in Managing your XT Server Locally from the Endpoint
on page 39.
Before you begin
Verify that you have the following:
•
An RS232 serial port cable for XT Server, provided with the basic cable kit.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 31
To Next Page
Loading...
