Figure 12: Serial port cable
•
A serial port terminal application, such as SecureCRT or PuTTY.
Procedure
1. Connect the serial port cable as follows:
Figure 13: Connecting a serial port cable
a. Connect the mini-USB end of the cable to the serial port on the XT Codec Unit.
b. Connect the DB (9 pin) end of the cable to the serial port on the computer.
2. Launch a serial port terminal application such as SecureCRT.
3. Establish the connection between the computer and the XT Server by configuring the
settings as follows:
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 32
To Next Page
Loading...
