Field Name Description
Address This field is only relevant if you set the Enable all addresses field
to No.
Enter the IP address or IP addresses of the computers allowed to
access XT Server.
Subnet Mask This field is only relevant if you set the Enable all addresses field
to No.
Enter the Subnet mask associated with the IP address or group
of IP addresses specified above.
3. From the web interface only, select Save.
4. To upgrade the XT Server, see Administrator Guide for Scopia XT Server for IP Office.
Managing your XT Server Locally from the Endpoint
You can set up and control the Scopia XT Server for IP Office from the endpoint's main menu, using
your XT Remote Control Unit.
This is only relevant if you connected a monitor to your system, as described in Connecting a Monitor to
the XT Server on page 25.
To perform advanced configuration XT Server from the endpoint itself, you must first enable advanced
configuration as described in Maintaining the XT Server Locally from the Endpoint on page 45.
See the following topics for more information:
Navigation
•
Accessing the Main Menu of the XT Server on page 39
•
Using the XT Remote Control Unit on page 40
•
Maintaining the XT Server Locally from the Endpoint on page 45
Accessing the Main Menu of the XT Server
About this task
After switching on the XT Server, the main menu appears and you can configure the system and check
the status.
To make calls, record videoconferences, share content, and control the camera, you must first connect a
camera, monitor, and microphone.
You navigate XT Server menus using arrow keys and pressing the ok/menu key on the XT Remote
Control Unit (for details, see Using the XT Remote Control Unit on page 40).
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 39
To Next Page
Loading...
