5. Use the arrow keys on the XT Remote Control Unit to position the image, and then press
ok/menu.
6. To configure network settings, select Next and continue with Configuring Network Settings
on page 58.
Configuring Network Settings
About this task
This procedure describes how to set up the network settings and the IP address the system uses for
placing a call.
If you are modifying the network settings after initial setup, navigate to Configure > Network > GLAN 1
from the Main menu. For more information, see Configuring GLAN Use on page 77.
Before you begin
This procedure is performed as part of the Quick Setup Wizard, after
Adjusting the Image Position on
page 56. Consult with your network administrator to configure these fields.
Access the quick setup wizard from the endpoint or web interface, as described in Accessing the Quick
Setup Procedure on page 53.
Procedure
1. Press ok/menu and select one of the following from the IP Address Mode list:
•
Automatic: (Default) Select this option if the system gets its IP address automatically
(using DCHP).
The IP address, Subnet mask, Gateway, and DNS fields appear as read-only. See
Table 12: Configuring IP addresses on page 59 for a description of these fields.
•
Manual: Select this option if you require a static IP address. We recommend this option
since external endpoints need to dial to this endpoint as an MCU. Enter the fields as
described in Table 12: Configuring IP addresses on page 59.
To secure SIP connections using TLS certificates, your system must have a static IP
address, since the system generates the certificate request using its IP address as the
Common Name (CN). For more information, see Securing Connections to the XT
Server Using TLS on page 88.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 58
To Next Page
Loading...
