Configuring the Screen Saver to Start Automatically
About this task
This is only relevant if you connected a monitor to your system, as described in Connecting a Monitor to
the XT Server on page 25.
The screen saver helps to protect your monitor from burn-in without switching it off. This can be useful in
situations when you stop using your Scopia XT Server for IP Office for a relatively short period of time.
You can do this procedure from the endpoint itself or from the XT Server web interface.
Procedure
1. Access the screen saver settings as follows:
•
From the endpoint's main menu, select Configure > General.
•
From the XT Server web interface, select the Basic Settings tab.
Figure 43: Configuring screen saver settings
2. Select Yes from the Screen Saver list.
3. Set the time after which the screen saver automatically starts on the display in the Minutes
field.
4. From the web interface only, select Save.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 76
To Next Page
Loading...
