•
Support for dual HD video streams, allowing presentations and video clips to be shared in resolutions of up to
1080p 60 fps, depending on the license.
This includes either video input from two cameras, or one video stream from the camera, and one presentation
stream from the PC.
•
Allows to easily share data and presentations with third-party endpoints.
•
High quality video and audio even with limited bandwidth or poor network conditions, by using two compression
methods:
–
H.264 Scalable Video Coding Technology (SVC).
SVC dramatically increases error resiliency and video quality without the need for higher bandwidth. It is
especially effective over networks with high packet loss (like wireless networks) which deliver low quality
video.
–
H.246 High Profile, which is a video compression standard used for bandwidth efficiency. This allows
quality video at much lower bit rates.
•
Ability to record videoconferences (requires license).
•
For an even better experience, Scopia Control enables you to place a call using the intuitive touch interface of
an Apple
®
iPad
®
(requires license).
•
Secure point-to-point video calls and videoconferences, via encrypted connections or using TLS certificates.
You can have up to three remote encrypted participants in a videoconference.
Important:
Using encryption is subject to local regulation. In some countries it is restricted or limited for usage. For more
information, consult your local reseller.
Technical Specifications
This section details the system specifications of the Scopia XT Server for IP Office you purchased. Refer
to this data when preparing system setup and afterwards as a means of verifying that the environment
still complies with these requirements:
•
For physical details of the system, such as the power requirements and weight of each component,
see
Table 1: Physical device specifications on page 7.
•
For specific video, audio, and control features of the system, such as supported codecs and web
browsers, see Table 2: Video, audio and control capabilities on page 8.
•
For network information of the system, such as network interface cards, see
Table 3: Network and
security capabilities on page 9.
Table 1: Physical device specifications on page 7 refers to the physical details of the device.
Table 1: Physical device specifications
Scopia XT Server for IP Office
System power requirements 100-240 VAC, 50/60 Hz, 1.8 A Max. for XT Codec
Unit and AC direct for the monitor
Maximum power consumption 100W, AC input 115VA (341 BTU/hr) at 40°C
Operating temperature 0°C to 40°C (32°F to 104°F)
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 About the Scopia XT Server for IP Office | 7
To Next Page
Loading...
