Modifying the System's Name on the Titlebar
About this task
This procedure describes how to configure the endpoint to use an alternate system name, such as the
SIP username, on the titlebar (Figure 38: Scopia XT Server for IP Office's titlebar on page 68). You
can also do this as part of the quick setup from the endpoint itself, as described in Setting the System
Name and Language on page 55.
The name displayed on the monitors participating in the videoconference (for example: John-Smith, or
9th-Floor-Room, or NY-Office) is based on the protocol of the call. If you are connecting over SIP, your
system's SIP username is used, while if you are connecting over H.323, your system's H.323 name is
used. For more information, see Registering the XT Server to IP Office on page 61 and Registering the
Scopia XT Server for IP Office with a Gatekeeper on page 84.
Figure 38: Scopia XT Server for IP Office's titlebar
Procedure
1. Access the system name settings:
•
From the XT Server web interface, select Administrator Settings > System >
Location.
•
From the endpoint's main menu, select Configure > Advanced > System > Location.
You need to enter the PIN required to access the Advanced settings. The default PIN
is 1234.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 68
To Next Page
Loading...
