Chapter 2 | Installation Workflow for Scopia
XT Server for IP Office
About this task
To safely set up and perform the required initial settings to start using the Scopia XT Server for IP Office, follow the
recommended workflow described below.
Procedure
1. Decide how to incorporate the XT Server into your deployment, as described in Planning the Topology of
the Scopia XT Server for IP Office Deployment on page 12.
For example, decide where to deploy the XT Server, and the ports to open.
2. Read through and familiarize yourself with the safety information (see Complying with Safety Regulations
on page 23).
3. Inspect the XT Server to verify that no shipping damage occurred, as described in Inspecting the Product
on page 23.
4. To quickly connect your XT Server, refer to the Quick Setup Guide for Scopia XT Server for IP Office. For
more detailed information on connecting the XT Server, see Setting up the Scopia XT Server for IP Office
on page 24, which includes:
•
Mounting the XT Server
•
Connecting the XT Server to the network
•
Connecting a monitor (optional)
•
Placing batteries in the XT Remote Control Unit, if you are connecting a display and configuring
from the endpoint interface.
5. If you are configuring from the web interface only, retrieve the system's IP address, as described in
Retrieving the IP Address of the XT Server on page 29.
6. Read through and familiarize yourself with how to control the XT Server and access both the endpoint
and web interface, as described in How to Control the XT Server on page 28. To use the XT Remote
Control Unit to manage the system, you must first connect a monitor, as described in Connecting a
Monitor to the XT Server on page 25. Otherwise, you can manage the system from the web interface
only (see Managing your XT Server from the Web Interface on page 28).
7. Register your license to activate the XT Server, as described in Registering and Enabling your Scopia XT
Server for IP Office license on page 47.
If you do not yet have your license key, you can set up the system in demo mode for a period of 24 hours.
After this time, you must enable your license key to use the system.
8. Perform the basic required configuration necessary to use the XT Server, such as the network and
gatekeeper settings, as described in Performing Basic Configuration on page 52.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Installation Workflow for Scopia XT Server for IP Office | 10
To Next Page
Loading...
