Procedure
1. Verify that the LED on the front panel of the XT Codec Unit is blinking.
2.
Turn on the XT Codec Unit by pressing the
Power key on the XT Remote Control Unit.
3. The system home page appears on the monitors, and you can configure the system and
check the status.
Important:
When you access the system for the first time only, the Quick Setup wizard is displayed
(for details, see
Accessing the Quick Setup Procedure on page 53).
Figure 19: Main menu
4. Select one of the options using the arrow keys of the XT Remote Control Unit.
Using the XT Remote Control Unit
This section explains how to use the XT Remote Control Unit to navigate through the system menus,
and lists the function of each key.
To use the XT Remote Control Unit to manage the system, you must first connect a monitor, as
described in
Connecting a Monitor to the XT Server on page 25. Otherwise, you can manage the system
from the web interface only (see Managing your XT Server from the Web Interface on page 28).
The XT Remote Control Unit has an improved design and increases usability to give you a smoother and
more efficient videoconferencing experience. Figure 20: The new XT Remote Control Unit on page 41
describes the functions of the XT Remote Control Unit.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 40
To Next Page
Loading...
