Configuring Network Settings
Part of the initial configuration is ensuring the network is properly set up. The settings are detailed in
these sections:
Navigation
•
Configuring GLAN Use on page 77
•
Registering the Scopia XT Server for IP Office with a Gatekeeper on page 84
Configuring GLAN Use
You can configure GLAN use for Scopia XT Server for IP Office.
Before you begin to configure GLAN use, you must prepare your network for videoconferencing. Consult
your network administrator for more information.
These sections describe step-by-step procedures to configure settings for GLAN use:
Navigation
•
Configuring IP Addresses on page 77
•
Configuring Network Connectivity on page 79
•
Enabling NAT and Firewall Traversal with Scopia XT Server for IP Office on page 81
•
Determining the Priority of Audio versus Video Quality on page 83
Configuring IP Addresses
About this task
To place calls, the system supports either IPv4-only mode, or dual IPv4 and IPv6 mode.
HTTP, SNMP, and AT commands management occurs in IPv4 only, even if you set the system to
support dual mode. You can configure the IPv4 address manually or automatically.
Media streams in the same conference can be a mixture of IPv4 and IPv6.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint on page 45.
Procedure
1. Access the general network settings, as follows:
•
From the XT Server web interface, select Administrator Settings > Networks >
Preferences > General.
•
From the endpoint's main menu, select Configure > Network.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 77
To Next Page
Loading...
