Figure 44: Enabling IPv6 mode
2. Set the Use IPv6 field to enable or disable IPv6 support.
3. From the web interface only, select Save.
4. Access the IP address settings, as follows:
•
From the endpoint, select either GLAN 1 or GLAN 2.
•
From the web interface, select Addresses under GLAN 1 or GLAN 2.
Figure 45: Configuring IP addresses from the web interface
5. Set the fields as described in Table 20: Configuring IP addresses on page 79.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 78
To Next Page
Loading...
