Before you begin
•
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint on page 45.
•
By default, remote management is enabled. If you changed this configuration, make sure that you
enable it as described in Enabling Remote Management on the Scopia XT Server for IP Office on
page 35.
Procedure
1. Access the remote download settings, as follows:
•
From the endpoint's main menu, select Administrator Settings > Utilities > Remote
Access > Download.
•
From the XT Server web interface, select Configure > Advanced > Utilities > Remote
Access > Download.
Figure 18: Enabling remote access to the XT Server
2. Set the fields as described in Table 10: Enabling remote upgrade on page 38.
Table 10: Enabling remote upgrade
Field Name Description
Download
Management
Configure whether to allow remotely downloading firmware or
patches to the XT Codec Unit via a Windows PC upgrade
program, as follows:
•
Select Yes to enable remote downloads to the XT Server.
•
Select No to disable remote downloads to the XT Server.
Enable all addresses Allow access to the XT Codec Unit from all or specific PCs, as
follows:
•
Select Yes to enable access to XT Server from any IP
address in a network.
•
Select No to allow access to specified computers only. If
selected, you must also configure the Address and SubNet
mask as described below.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 38
To Next Page
Loading...
