Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint on page 45.
Procedure
1. Access the network settings as follows:
•
From the XT Server web interface, select Administrator Settings > Networks.
•
From the endpoint's main menu, select Configure > Advanced > Networks.
2. Select Parameters under GLAN.
Figure 46: Configuring the GLAN parameters from the web interface
3. Set the field as described in Table 21: Configuring network connectivity on page 81.
To avoid connectivity issues, match these settings to the equivalent settings in the network.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 80
To Next Page
Loading...
