Avaya XT Series

To Next Page

To Previous Page

Configuring Basic Network Settings on page 29

Configuring Basic Gatekeeper Settings on page 30

Configuring Basic SIP Settings on page 31

Installing Avaya Room System XT Control to Use Keyboard and Mouse (Avaya XTE240) on

page 32

Setting the System Name, Language, and Call Method

About this task

Note:

This step is for the manual configuration of your Avaya XT Series. If you have chosen the

auto-provisioning (cloud) method of configuration, this step is not available.

The first screen in the Quick Setup wizard enables you to define the name of your Avaya XT

Series, the country, the menu language, and the protocol the system uses for calls. The unit's

name is displayed on the system's title bar and to other meeting participants. For example, Hong-

Kong, 9th-Floor-Room, or NY-Office. There is also a unicode system name to enable non-

English characters, available on the web interface only. For more advanced settings of the system

name, see Deployment Guide for Avaya XT Series.

After initial setup, you can modify these settings by selecting Configure > General from the

endpoint's menus, or from the web interface select Basic Settings > Preferences > General.

Before you begin

Access the quick setup wizard from the endpoint or web interface, as described in

Configuring

Basic Settings with the Quick Setup Wizard on page 27.

Procedure

1. Define the name and language.

2. To adjust the image on your monitor, select Next and continue with Adjusting the Image

Position on page 28.

If performing the quick setup from the web interface, access the quick setup from the

endpoint to adjust the image. This can be done at any time.

Avaya XT Series - Page 28