Avidyne IFD540 - Page 317

IFD500 Series Pilot Guide
Aux Subsystem 5-81
Left Side Factory Settings
The “left side factory settings” preset returns only the datablocks
on the left side to factory defaults, as follows (from top to bottom):
IFD with radio
IFD without radio
Primary Com/VLOC
To Waypoint Information
VLOC Radio
To Waypoint ETA
Decoded VLOC Identifier
Active Approach
Navigation Mode
Navigation Mode
Left Side Transponder
The “left side transponder” preset item will only be displayed if the
IFD is configured to interface with a transponder. The left side
transponder datablocks are as follows (from top to bottom):
IFD with radio
IFD without radio
Primary Com/VLOC
To Waypoint ETA
Com/VLOC Standby #2
Active Approach
Transponder Thumbnail
Transponder Thumbnail
Left Side Traffic
The “left side traffic” preset item will only be displayed if the IFD is
configured to interface with a traffic sensor. The left side traffic
datablocks are as follows (from top to bottom):
IFD with radio
IFD without radio
Primary Com/VLOC
To Waypoint ETA
Com/VLOC Standby #2
Active Approach
Traffic Thumbnail
Traffic Thumbnail
Custom Settings
The “custom settings” preset consists of the complete set of
datablock settings that have been most recently modified by the