2-1
2. PRECAUTIONS OF
INSTALLATION/TRANSPORTATION
Precautions of Installation
Transportation
2.1 PRECAUTIONS OF INSTALLATION
Pay attention to the following matters before unpacking and installation.
Do not install in a place where vibration may occur.
Keep the scanner out of direct sunlight. Do not install near a heat source.
Do not place the scanner around materials which shut off the circulation of air.
Do not install in a humid or dusty place.
Use care not to scratch the glass surface of the scanner or the document holding pad
with a clip or staple.
Do not use the wall socket with connecting devices which may generate noise, for
example, air-conditioner, etc.
Use a suitable AC power source.
Place the scanner on a level surface.
2.2 TRANSPORTATION
To move the scanner from where it is installed, for repair or any other reason, make sure to
observe the following conditions:
(1) Turn off the power of the scanner.
(2) Remove the power cable.
(3) Put the scanner in the packing case with the packing material.
To Next Page
Loading...
