B. Braun Infusomat compact plus - Set-up and start-up; 7.1 Setting up and connecting the device; 7.2 Powering on the device for the first time; 7.3 Configure device options

22
Set-up and start-up
7.1.5 Connecting the device to the
mains electricity
DANGER! Risk of death from electric
shock.
Q
Connect the power cable with mains
connection to the device.
Q
Position the power cable so that it
does not present a trip hazard.
Q
Plug the mains plug into the socket.
7.1.6 Operating the device on
battery power
Q
Ensure that the battery in the device is
fully charged.
7.2 Powering on the device
for the rst time
Q
Device switched on
Q
Select and insert the line,
see section 8.2.
Q
Congure additional device settings,
see section 7.3.
7.3 Congure device options
Q
Device switched on
Q
No patient connected
Q
No ongoing infusion
Q
Press the Menu key.
The main menu is displayed.
Q
Select Settings... and press OK to
conrm.
The “Settings” screen is displayed.
7 Set-up and start-up
7.1 Setting up and connecting
the device
7.1.1 Attach/remove the compact
plus
pole clamp
Note: The compact
plus
pole clamp is xed to
the device.
Q
The compact
plus
pole clamp should
only be removed or re-attached by a
service technician.
7.1.2 Operating the device on a stand
Q
Press the lever on the compact
plus
poleclamp.
Turn the compact
plus
pole clamp to
thedesired position.
Q
Turn the compact
plus
pole clamp until
the lever clicks into place.
7.1.3 Operating the device in the
compact
plus
station
Q
Follow the compact
plus
station instruc-
tions for use.
7.1.4 Operating the device on a wall rail
Q
Press the lever on the compact
plus
poleclamp.
Turn the compact
plus
pole clamp to the
desired position.
Q
Turn the compact
plus
pole clamp until
the lever clicks into place.
Q
Make sure that the compact
plus
pole
clamp is not xed at the point where
the wall rail is attached to the wall.
38932401_Infusomat_compactPlusP_EN_IFU_1020_v5.indd 22 15.10.2020 17:47:27