54
Instructions for use for accessories
19 Instructions for use for
accessories
19.1
Interface lead 12 V CP
(8718020)
Connect the device for charging the
battery with vehicle socket
WARNING! Risk to the patient from
electric shock!
Q
Do not use the device on patients if
the emergency ambulance is con-
nected to the vehicle charger.
Q
Plug interface cable 12V CP into the
accessory port on the side of the
device.
Q
Plug interface cable 12V CP into the
vehicle socket.
Q
If necessary, remove the red adapter
on the vehicle socket by gently turning
it and pulling on it at the same time.
The green LED on the electronics box
shows the operating voltage.
19.2
Interface lead sta call
CP (8718030)
Connect device to the sta call system
The sta call system must comply with the
requirements of VDE 0834.
Q
Observe country-specic regulations
on sta calls.
Q
Plug the STAFF CALL interface lead
CP into the accessory port on the side
of the device or service port on the
Station compact
plus
.
Q
Connect the STAFF CALL interface lead
to the sta call system.
Q
Set the sta call operating mode using
the service programme. Follow the
sta call system procedure.
Q
Check the sta call before each use of
the device.
19.3
Station compact
plus
(8717141)
Station for up to three pumps. For further
information see “Instructions for Use” of
Station compact
plus
.
19.4
Data module compact
plus
(8717160)
Central interface for a connection to an
external IT system. For further information
see “Instructions for Use” of Datamodule
compact
plus
.
19.5
Short stand SP (8713135)
Use the short infusion stand to attach
an infusion container to the pump.
Q
Caution: Note that the pump con-
nected to the short infusion stand
can only be used on a at surface
and must not be carried by the
handle.
Q
Only use infusion containers with
max. 1000ml with the short infu-
sion stand.
38932401_Infusomat_compactPlusP_EN_IFU_1020_v5.indd 54 15.10.2020 17:47:32
To Next Page
Loading...
