Baldor MicroFlex - Tools and Miscellaneous Hardware; Other Information Needed for Installation

www.baldormotion.com
3-2 Basic Installation MN1919
H A PC with the following specification:
Minimum specification Recommended specification
Processor Intel Pentium 133MHz Intel Pentium 200MHz or faster
RAM 32MB 64MB
Hard disk space 40MB 60MB
CD-ROM ACD-ROMdrive
Serial port RS232 or RS485 serial port (depending on MicroFlex model)
Screen 800 x 600, 256 colors 1024 x 768, 256 colors
Mouse A mouse or similar pointing device
Operating system Windows 95, Windows 98, Windows ME,
Windows NT, Windows XP or Windows 2000
3.1.3 Tools and miscellaneous hardware
H Your PC operating system user manual might be useful if you are not familiar with
Windows
H Small screwdriver(s) with a blade width of 3mm or less for connector X1, and 2.5mm (1/10
in) or less for connector X3.
H M5 screws or bolts for mounting the MicroFlex
H Crimping tool.
3.1.4 Other information needed for installation
This information is useful (but not essential) to complete the installation:
H The data sheet or manual provided with your motor, describing the wiring information of
the motor cables/connectors
H Knowledge of whether the digital input signal will be ‘Active Low’ or ‘Active High’.