www.baldormotion.com
6-6 Configuration MN1919
3. In the Select Controller dialog, go to the drop down box near the top and select the PC serial
port to which the MicroFlex is connected.
(If you are unsure which PC serial port is connected to the MicroFlex, select Scan all serial
ports).
Click Scan to search for the MicroFlex.
When the search is complete, click on MicroFlex in the list to select it, and click the Select
button.
This check box is already selected for you. When you
click S elect, it means that the Commissioning Wizard
will start automati call y.
Note: If the MicroFlex is not listed, check the serial lead between the MicroFlex and the
PC and that the MicroFlex is powered correctly. Click Scan to re-scan the ports.
To Next Page
Loading...
