Save to USB
The Save to USB screen provides for saving sensor Configuration to a USB flash drive. The saved configuration information can be used
as a backup or as a way to clone configuration information for other sensors.
NOTE: On the Emulator, this option is Save Configuration.
Main Menu > System > Sensor Configuration > Save to USB
Load from USB
The Load from USB screen provides for restoring sensor Configuration from a USB drive.
NOTE: On the Emulator, this option is Load Configuration.
Main Menu > System > Sensor Configuration > Load from USB
Match Time Limit
When the sensor is configured as a Match sensor, this screen provides for adjusting the amount of time allotted for the sensor to deter-
mine if a pattern is good. This is essentially a timeout value. If set too high, the sensor can miss triggers while trying to match a bad
pattern.
NOTE: This menu option is only available when the Sensor Type selected is Match.
Main Menu > System > Sensor Configuration > Match Time Limit
Reset to Defaults
Resets all sensor configuration to factory defaults.
Main Menu > System > Sensor Configuration > Reset to Defaults
iVu Series Image Sensor
Rev. E www.bannerengineering.com - tel: 763-544-3164 19
To Next Page
Loading...
