Barco ClickShare Service Guide

7. Preparing the buttons
7. PREPARING THE BUTTONS
Overview
• Pairing
• Pre-install of the Launcher service
7.1 Pairing
Pairing of the Buttons with the Base Unit
To be able to use a Button it should be assigned to the Base Unit you are using. This process is called pairing. By default, the four
Buttons delivered with the ClickShare set are already paired to the specific Base Unit.
In case you buy additional Buttons or when a Button should be assigned to another Base Unit, the But
ton needs to be paired (again).
When updating the Base Unit software, it is advised to also pair your Buttons with the Base Unit to update their software.
A Button can only be paired to one Base Unit at a time.
The Button w ill always make connection to the Base Unit it was last paired to.
To pair a Button t o the Base Unit
1. Insert the Button in the USB port at the front of the Base Unit you are using.
Image 7-1
Inserting Button into the Base Unit
R5900006 CLICKSHARE 04/12/2013 49

Barco ClickShare Specifications

General

Plug-and-Play	Yes
Video Outputs	HDMI
Supported Resolutions	Up to 4K UHD
Number of Concurrent Users	Up to 8 (depending on the specific model)
Operating System Compatibility	Windows, macOS
Security Protocols	WPA2
Maximum Resolution	3840x2160
Connection	USB
Encryption	AES
Supported Video Formats	H.264
Wireless Technology	Wi-Fi