Why cannot install optional features on Bard Site-Rite 8 Medical Equipment?
If you are unable to install optional features on your Bard Medical Equipment, ensure that the feature activation key you are using matches the serial number of your system, as the key is system-specific.
Why can't I connect my Bard Site-Rite 8 Medical Equipment to the network?
If you are having trouble connecting to a desired network with your Bard Medical Equipment, check these steps: 1. Confirm that the DICOM features are activated on the system. 2. Confirm WiFi is enabled or the Ethernet cable is connected. 3. If using WiFi, check the WiFi signal strength. 4. Contact your network administrator.
What to do if Bard Medical Equipment system becomes unresponsive?
If your Bard Medical Equipment system becomes unresponsive, press and hold the power switch on the side of the device until the system shuts down (this will take approximately 10 seconds). Then, turn the system back on.
What to do for Probe Disconnect Error EC:204 on Bard Medical Equipment?
If you see Error Code EC:204 on your Bard Medical Equipment, it indicates a probe disconnect error. Ensure the probe is securely connected to the system.
How do I fix Error Code EC:102 on Bard Medical Equipment?
If you are getting Error Code EC:102 on your Bard Medical Equipment, it means there's a USB storage device error. The USB storage device may be full or not compatible. Try replacing the USB storage device.
What causes Error Code EC:103 on Bard Medical Equipment?
If you encounter Error Code EC:103 on your Bard Medical Equipment, which indicates a hard drive error, restart the system.
How to troubleshoot Error Code EC:104 on Bard Site-Rite 8 Medical Equipment?
If you see Error Code EC:104 on your Bard Medical Equipment, it indicates a printer error. First, verify that the printer is on and has paper. Then, check the printer’s power cable and its connection to the system.
What to do if my Bard Medical Equipment system does not charge?
If your Bard Medical Equipment is not charging, it could be a battery charging failure. First, unplug the AC adapter and plug it back into the system. If you are charging the battery in temperatures exceeding 32°C, the system may need to be turned off.
Why A/C adapter indicator does not change states when A/C power is connected to my Bard Medical Equipment?
If the A/C adapter indicator on your Bard Medical Equipment doesn't change states when A/C power is connected, it might be a connection error. First, unplug the AC adapter and plug it back into the system. If necessary, restart the system.
Why is my Bard Site-Rite 8 Medical Equipment beeping every minute?
If your Bard Medical Equipment system is playing a sound every minute, it likely indicates a low battery. Connect the system to a power source to continue operation and recharge the battery.
Critical warnings and cautions for operating the Site-Rite® 8 Ultrasound System safely.
Specific warnings and cautions for Cue™ and Pinpoint™ GT needle guidance.
Setup, activation, and interface usage for the Cue™ Needle Tracking System.
Setup, calibration, and tracking procedures for Pinpoint™ GT Needle Technology.
Resolving common errors for the Site-Rite® 8 Ultrasound System.
Specific troubleshooting for Cue™ and Pinpoint™ GT tracking systems.
General| Display Type | LCD |
|---|---|
| Transducer Ports | 1 |
| Battery Type | Rechargeable Lithium-Ion |
| Portability | Portable |
| Manufacturer | Bard |
| Power Source | AC Adapter or Battery |
| Image Modes | B-mode, M-mode |
| Needle Guidance | Yes |
| Intended Use | Vascular access procedures |
To Next Page