AW00097603000 Standard Features
Basler aviator GigE 255
User Set
The active configuration set is stored in the camera’s volatile memory and the settings are lost if the
camera is reset or if power is switched off. The camera can save most of the settings from the
current active set to a reserved area in the camera’s non-volatile memory. A configuration set that
has been saved in the non-volatile memory is not lost when the camera is reset or switched off.
There is one reserved area in the camera’s non-volatile memory available for saving a configuration
set. A configuration set saved in the reserved area is commonly referred to as a "user set".
The three available user sets are called User Set 1, User Set 2, and User Set 3.
When the camera is running, the saved user set can be loaded into the active set. The saved user
set can also be designated as the "startup" set, i.e., the set that will be loaded into the active set
whenever the camera is powered on or reset. Instructions for loading a saved user set into the
active set and for designating which set will be the startup set appear later in the Configuration sets
section.
Designating a Startup Set
You can designate the default set or the user set as the "startup" set. The designated startup set
will automatically be loaded into the active set whenever the camera starts up at power on or after
a reset. Instructions for designating the startup set appear later in the Configuration Sets section.
The values for the luminance lookup table are not saved in the user set and are
lost when the camera is reset or switched off. If you are using the lookup table
feature, you must reenter the lookup table values after each camera startup or
reset.
To Next Page
Loading...
Need help?
General
