Basler scout GigE - Page 363

AW00011916000 Revision History
Basler scout GigE 353
AW00011913000 16 June 2009 Updated sensor name "Micron MT9V022" to "Aptina MT9V022" in
Section 1.2 on page 2.
Removed the notes designating the information about the
scA1300-32gm/gc cameras as preliminary in Section 1.2 on page 2.
Updated minimum allowed exposure times in Section 9.7 on page 141.
Updated the constants C
1
, C
2
, and C
3
for scA1300-32gm/gc cameras in
Section 9.13 on page 167.
Added the digital shift feature in Section 12.3 on page 232.
Corrected the indications of x offset and y offset in Figure 72 in Section 12.4
on page 238 and in Figure 69 in Section 12.9.1.2 on page 289.
Added the reverse X feature in Section 12.7 on page 278.
Removed the statement that auto functions have no effect on frame rate in
Section 12.9.1 on page 287 and added a note that frame rate may be
affected if exposure auto is used in Section 12.9.3 on page 296.
Added a reference to the reverse X feature in Section 12.9.1.2 on
page 289.
Replaced "Auto Gain Raw" by the correct "Gain Raw (All)" parameter name
in Section 12.9.2 on page 294.
Replaced "Auto Exposure Time Abs" by the correct "Exposure Time Abs"
parameter name in Section 12.9.3 on page 296.
Added the auto function profile feature in Section 12.9.4 on page 298 and
adjusted Section 12.9.2 on page 294 and Section 12.9.3 on page 296
accordingly.
Added the trigger delay feature in Section 12.13 on page 306.
Added the acquisition status feature in Section 12.14 on page 308 and
added a reference in Section 9.2.3 on page 106.
Added the high gain and auto functions factory setups and the standard
factory setup (formerly the "default set") in Section 12.18 on page 319.
Removed the statement that settings for frame transmission delay and inter
packet delay are not saved in the user sets in Section 12.18 on page 319.
Added descriptions about resetting the frame counter and about relating
frame and trigger input counter in Section 13.3 on page 330.
Corrected the maximum value for the frame counter in Section 13.3 on
page 330.
Added the trigger input counter feature in Section 13.5 on page 335.
Doc. ID Number Date Changes