2.6.3 Duties of the personnel
The personnel must comply with the following safety requirements:
•
Read and understand the operating instruction manual.
•
Refrain from any working practices which may compromise safety.
•
Use personal protection equipment if required.
•
Observe all the safety instructions and danger warnings on the machine.
•
Check the machine for outwardly noticeable damage and defects at least once
a day. If changes occur in the machine or in its operating behaviour and these
could impact on safety, stop the machine immediately and report the fault to
the department/person responsible.
2.7 Safety concept
The following components are part of the safety concept of the compressor unit.
2.7.1 Structure
Fig. 2 Final pressure safety valve
2.7.2 Function
Safety valves
All intermediate pressures and the final pressure are protected by safety valves. All
valves are set in the factory to the pressure applicable for each individual stage
and sealed.
The safety valves open as soon as the set opening pressure is exceeded.
For the opening pressures of the safety valves, see Chapter 4.1 Technical data
about the compressor unit, Page 39.
2 | For your safety
OPERATING MANUAL
26/106
A_Compact-Line_002_en
10-10-2016
To Next Page