Code: IU.01.09.0007
Version / Revision: 6.001
Page: 68 de 143
Ultrasonic washer
Model: E0201
After the water supply in the tank and the temperature reached, the
equipment enters the cleaning stage.
Note: If the heating function is not programmed, the heating phase
is omitted.
The water of the equipment will drain, after the drain, the supply will
start again when reaching the low level, the equipment will start the
flushing step.
The water of the equipment will be drained. The cleaning and
flushing steps will repeat in accordance with the number of cleaning
phases programmed;
After the last flush, the cycle has ended.
Once all stages of the process have been completed, the
"COMPLETE CYCLE" screen will be shown. The "Cycle time"
indicates the total time and the "End of cycle time" indicates the
exact moment when the cycle is completed. At the end of the cycle,
a bell will activate to inform the operator about the end of the cycle.
Press the "OK" key to end the cleaning process, allowing the
operator to open the Ultrasonic washer cover. The next screen will
show itself in new.
Pressing the "Print last cycle" key will print the record of the
parameters of the cycle that has just been executed.
To Next Page
Loading...