baxter Flo-Gard 6201 - Failure Identification Codes

07-19-B1-688 FLO-GARD 6201 VOLUMETRIC INFUSION PUMP SERVICE MANUAL 7-7
Troubleshooting Failure Identification Codes
Failure Identification Codes
Specific errors which may occur during pump operation are represented by
Failure Identification Codes. When the alarm message FAILURE occurs, it is
accompanied by a two-digit code number. This code is the Failure
Identification Code. The last 10 Failure Identification Codes (including alarm
codes except DOOR OPEN and AIR alarms occurring in the stopped mode)
are stored in the pump’s memory, along with the date and time at which the
alarm occurred. The Failure Identification Codes can be used to determine the
nature of a pump failure and to troubleshoot its cause.
RAMP PDP ENTER
DATA
Note: Alert message
or Ramp PDP can
only appear on
pumps running
software versions
1.09 or higher.
Yellow No flow None The pump is waiting for Ramp PDP data to be
entered. Either enter the data (as described in the
Operator’s Manual), or press the OPTIONS key
to leave the PDP mode.
RAMP PDP RATES
HIGH
Note: Alert message
or Ramp PDP can
only appear on
pumps running
software versions
1.09 or higher.
Yellow No flow None The Programmed Ramp PDP parameters have
resulted in a calculated flow rate that exceeds the
pump’s capabilities. To correct this alert, either
reduce the volume for total VTBI or increase the
Run Time.
RESUME PDP
Ramp Profile Phase
Note: Alert message
or Ramp PDP can
only appear on
pumps running
software versions
1.09 or higher.
Yellow No flow PRI START
or STOP
The pump is asking if it should resume the Ramp
PDP where it was interrupted. Do one of the
following:
Press PRI START to start fluid delivery or press
STOP to cancel the alert.
Table 7-2 Alert Messages — continued
Alert Message LED Flow Status
Key
Pressed Alert Condition