MX680RD User’s Manual
Chapter 2: BIOS Setup
BIOS Update Related Procedure
1. After the BIOS is flashed, shut down the system.
2. Disconnect all power connections from power supply to the mainboard.
3. Clear the CMOS (For at least 30 seconds) (Check Section 1.10.5 for details).
4. Reconnect all power connections from power supply to the mainboard.
5. When the system is booting at first time after the new BIOS is flashed, it is
recommended to enter the BIOS; load the option “Load Optimized Defaults”, and
then “Save and Exit Setup”.
IF ANY OF THE ABOVE STEPS IS NOT FOLLOWED, IT MAY CAUSE THE FLASHED BIOS
NOT FUNCTION PROPERLY.
The items under each BIOS category described in this chapter are under continuous
update for better system performance. Therefore, the description may be slightly
different from the latest BIOS and should be held for reference only.
To Next Page
Loading...
