BCM MX680RD - LAN2 PXE Oprom [Disabled]; Restore AC Power Loss [Power Off]; Flash Protection Range Registers (FPRR) [Disabled]; GPIO Group Control [Disabled]

MX680RD User’s Manual
99
2.5.2.4 LAN2 PXE OpROM [Disabled]
Enabled or Disabled boot option for LAN2 controller
Configuration options: [Disabled], [Enabled]
2.5.2.5 Restore AC Power Loss [Power off]
Specify what state to go to when power is re-applied after a power failure (G3 state)
Configuration options: [Power on], [Power off], [Last State]
2.5.2.6 Flash Protection Range Registers (FPRR) [Disabled]
Enable Flash Protection Range Registers
Configuration options: [Disabled], [Enabled]
2.5.2.7 GPIO Group Control [Disabled]
Configure the digital GPIO pins
Configuration options: [Disabled], [Enabled]
2.5.2.8 Amplifier GAIN (db) [15.3db]
Select Amplifier GAIN value
Configuration options: [15.3db], [21.2db], [27.2db], [31.8db]