Bdcom S6508 - 4.5 IOS Installation and Upgrade

BDCOM S6508 Switch Hardware Installation Guide
Chapter 4 System debug
4.1 Debug flow
Pre-check
Start system
Check Init status
Is software exist?
Install software
Config parameter
Run self-test
Debug over
Set up cofiguration
envirament
yes
no
Finish Installation
4.2 set up configurable environment
4.2.1 set up configurable environment by console
(1) As shown in figure 4-1, to set up local configurable environment, you need
connect PC’s COM port with 6508’s console by RS-232 cable
- 41 -