Operation
69
RCMS460-490_D00067_03_M_XXEN/12.2017
1. Relay mode
Set the relay mode of operation:
N/O N/O operation. Relay only switches in the event of an alarm.
N/C N/C operation. Relay only switches in the event of an alarm.
N/O-T N/O operation. Relay switches when there is an alarm or a
test.
N/C-T N/C operation. Relay switches when there is an alarm or a
test.
off Contacts of the relay are always open*.
on Contacts of the relay are always closed*.
* This function can also be activated via the BMS bus. By sending the command
"off" or "on" via the BMS bus, the switching of the relay can be activated. This relay
does not respond to alarms. It only serves as a signal converter (BMS-bus signals/
relay contact signal.
2. Alarm
on Relay switches in the event of an alarm.
off Relay does not switch in the event of an alarm.
3. Prewarning
on Relay switches in the event of a prewarning.
off Relay does not switch in the event of a prewarning.
4. Device error
on Relay switches in the event of a device error.
off Relay does not switch in the event of a device error.
5. Ext. Alarm
on Relay switches in the event of an external alarm*.
off Relay does not switch in the event of an external alarm*.
* Alarm on an external device the address of which has been set to "on" in the
"Alarm addresses" menu. (see “Settings menu 9: Alarm addresses” on page 71).