81
RCMS460-490_D00067_03_M_XXEN/12.2017
7. Tests, service, troubleshooting
7.1 Periodic verification
The RCMS system monitors itself during operation. We recommend that the
test function is called on each connected RCMS460 or RCMS490 at regular in-
tervals. You call a test as follows:
Select the standard display and press the "TEST" button of the RCMS…
for at least one second
or press an external test button
or start the "TEST" function in the Control menu.
Observe the applicable national and international standards which require re-
gular testing of electrical equipment.
7.2 Maintenance and service
The RCMS system does not contain any parts that must be maintained.
Bender would be delighted to provide on-site service for commissioning and
service personnel training.
Please contact our Service Department for more information. You will find the
address on page 9 of this manual.
To Next Page
Loading...
Need help?
General
