EasyManuals Logo

Benelli TRK 502 User Manual

Benelli TRK 502
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
EN
6
6 - 12
Periodic maintenance and adjustment
8. Install the engine oil drain bolt and its new
gasket, and then tighten the bolt to the spe-
cied torque.
9. Rell with the specied amount of the re-
commended engine oil, and then install and
tighten the oil ller cap.
TIP
Be sure to wipe o spilled oil on any parts
after the engine and exhaust system have co-
oled down.
NOTICE
In order to prevent clutch slippage
(since the engine oil also lubricates
the clutch), do not mix any chemical
additives. Do not use oils with a diesel
specication of “CD” or oils of a higher
quality than specied. In addition, do
not use oils labeled “ENERGY CON-
SERVING II” or higher.
Make sure that no foreign material
enters the crankcase.
10. Start the engine, and then let it idle for se-
veral minutes while checking it for oil leakage.
If oil is leaking, immediately turn the engine
o and check for the cause.
TIP
After the engine is started, the engine oil level
warning light should go o if the oil level is
sucient.
NOTICE
If the oil level warning light ickers or re-
mains on even if the oil level is correct, im-
mediately turn the engine o and have a
Benelli dealer check the vehicle.
11. Turn the engine o, wait a few minutes un-
til the oil settles, and then check the oil level
and correct it if necessary.
Tightening torque:
Engine oil drain bolt:
22 N·m (2.2 kgf·m, 16.2 lb·ft)
Recommended engine oil:
PETRONAS POWER SPEED 4T
Oil quantity:
Oil change:
3 L (0.80 US gal, 0.7 Imp gal)
With oil lter removal:
3.2 L (0.84 US gal, 0.72 Imp gal)

Table of Contents

Other manuals for Benelli TRK 502

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Benelli TRK 502 and is the answer not in the manual?

Benelli TRK 502 Specifications

General IconGeneral
Displacement500 cc
Transmission6-speed
Fuel Tank Capacity20 liters
Seat Height800 mm
Wet Weight235 kg
Bore x Stroke69 mm x 66.8 mm
Compression Ratio11.5:1
ClutchWet multi-plate
FrameSteel trellis
Wheelbase1505 mm
Ground Clearance190 mm
Max Power47.6 hp (35 kW) @ 8500 rpm
Max Torque46 Nm @ 6000 rpm
Front Suspension50 mm upside-down fork
Front BrakeDouble floating discs, 320mm, 4-piston calipers
Rear BrakeSingle 260 mm disc
Fuel SystemElectronic Fuel Injection (EFI)
ABSDual-channel ABS
Front Tire120/70 R17
Rear Tire160/60 R17
Engine TypeLiquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder

Related product manuals