Bernina 500 - Activating the Bobbin Thread Indicator; Activating the Audio Signals

Setup Program
56
> Touch the icon «Monitoring settings».
> To switch off the upper thread indicator, move the switch in the upper area to «0».
> To switch on the upper thread indicator, move the switch in the upper area to «I».
Activating the bobbin thread indicator
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Monitoring settings».
> To switch off the lower thread indicator, move the switch in the lower area to «0».
> To switch on the lower thread indicator, move the switch in the lower area to «I».
3.4 Activating the audio signals
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Audio signals».
> Touch the switch (1) to deactivate any audio signals in general.
> Touch the switch (1) again to activate any audio signals in general.
> In the section (2) touch the icons «1–4» to set up the desired signal for the selection of an embroidery
motif.
> In the section (2) touch the icon «Loudspeaker» to deactivate the signal for the selection of an
embroidery motif.
> In the section (3) touch the icons «1–4» to activate the signal for the selection of functions.
> In the section (3) touch the icon «Loudspeaker» to deactivate the signal for the selection of functions.
2
1
3