Creative embroidering
75
> Touch the icon «Embroider trims» once the reference points have been embroidered.
– An animation displays that the fabric has to be re-clamped.
> Remove the hoop and spin the fabric in such a way that the embroidered reference points are in the
upper embroidery field of the hoop and the reference points are located at least 3 cm (1.18 inch) away
from the upper edge of the hoop.
> Attach the hoop.
> Touch the icon «Confirm».
– The hoop is automatically moved close to the reference point.
– The icon «AUTO» is active and the hoop automatically moves close to the last reference point.
> Use the arrow icons to determine the side of the embroidered section on which you want to position the
next reference point.
> Turn the «Upper multifunction knob» or «Lower multifunction knob» to precisely position the hoop.
> Touch the icon «Confirm».
> Press the button «Start/Stop» and continue to embroider.
> Repeat these steps until the required length of the trim has been achieved.
Duplicating the embroidery motif
The active embroidery motif is duplicated.
> Select an embroidery motif.
> Touch the icon «i»-Dialog.
To Next Page
Loading...
