Bernina 700 - Calibrating the Embroidery Hoop; Entering the Fabric Thickness

Setup Program
55
Calibrating the embroidery hoop
The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The embroidery module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrate the embroidery hoop».
> Select the desired embroidery hoop and follow the instructions in the display.
> Touch the icon «Delete» (1) to delete the present calibration.
> Center the needle via the arrow icons on the display.
1
Entering the fabric thickness
If the fabric thickness is more than 4 mm as for e.g. toweling, it is recommended to select 7.5 mm or
10mm. The thicker the fabric, the slower the embroidery speed of the machine. When the machine is
switched off, the alterations are reset to the default setting 4 mm.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Select the fabric thickness».
> Select fabric thickness.