Bernina 700 - Winding the Bobbin Thread

Embroidery preparation
42
> Pull the thread loop (14) to the back.
14
> Pull the thread beneath the presser foot from back to front over the thread cutter (15) and cut.
15
Winding the bobbin thread
The bobbin thread can be wound while embroidering if the swiveling spool holder is used for winding.
Prerequisite:
• The foam pad, the thread spool and the appropriate thread disc are positioned.
> Attach the empty bobbin on the winding unit (1) so that the silvery sensor surface is down.
1
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the thread pretension clockwise (3).