Creative embroidering
76
> Push the button «Start/Stop» and embroider the border.
– The embroidery motif must be embroidered completely.
> Touch the icon «Endless Embroidery» when the reference points have been embroidered.
– An animation indicates that the fabric must be rehooped.
> Remove the hoop and rehoop the fabric so that the stitched out reference points are in the upper part of
the embroidery area and at least 3 cm (1.18 inch) from the top edge of the hoop.
> Attach the hoop.
> Touch the icon «Confirm».
– The embroidery hoop is moved automatically close to the reference point.
– The icon «AUTO» is activated and the hoop moves automatically near the last reference point.
> Via the arrow icons, determine on which side of the embroidered part the next reference point shall be
placed.
> Turn the «Upper Multifunctional knob» or the «Lower Multifunctional knob» to position the hoop
exactly.
> Touch the icon «Confirm».
> Push the button «Start/Stop» and resume embroidering.
> Repeat these steps until the desired length of the border is embroidered.
To Next Page
Loading...
