Berthold Duo Xpert - Det.-Temp. Alarm Behaviour

LB 470 Level 7 Main Menu Device Setup
56925BA2 Rev. 03, 11/2017
145
Det.-Temp. Alarm Behaviour
Device settings | Setup | Alarms | Det.-Temp. Alarm Behaviour
The behaviour in case of alarm (NE107 status) can be set for the detector temper-
ature in the submenu ″Det.-Temp. Alarm Behaviour ″.
1
2
3
4
Selection arrow NE107 Status
Selection
″
No Status
″
(no Event Viewer, relay circuit)
Selecting
″
Out of specification
″
(Event Viewer, relay circuit)
Selection
″
Failure
″
(Event Viewer, the relay circuit)
Fig.
128 Submenu ″Det.-Temp. Alarm Behaviour“
NOTICE
If the detector alarms are set to "Failure", the measurement is switched in the
error current during the occurrence of a temperature alarm. Monitoring of the
PV in the master display is therefore no longer possible.